Labview Embedded with TI Microcontrollers= Just in Time for NI Week 2012

SPAMUSER — Sat, 04 May 2013 08:18:08 GMT

we will create a project in Labview that will open a connection to the LM3S8962 evaluation board, it will see the status of the push buttons on the spoils, likewise activate the horn and finally show numeric characters on your screen LCD. The front panel is connected to the evaluation board is shown in the following figure decibel.ni.com/.../DOC-29381

Labview Embedded with TI Microcontrollers= Just in Time for NI Week 2012

SPAMUSER — Fri, 03 May 2013 01:47:43 GMT

Labview Embedded with TI Microcontrollers= Just in Time for NI Week 2012

SPAMUSER — Fri, 03 May 2013 01:45:43 GMT

pulse width modulation between labview and LM3S8962 see link

www.youtube.com/watch

Labview Embedded with TI Microcontrollers= Just in Time for NI Week 2012

Vito Casa — Wed, 05 Sep 2012 23:49:00 GMT

I've used the EK-LM3S8962 with LabVIEW to program it and it's easy to use. Got a simple etch-a-sketch program going in 3 minutes after power up. Truley amazing. The only problem is that the LM3S8962 is over 6 years old. How about adding the DK-LM3S9D96 and Stellaris Launchpad to the list of Tier 1 boards. (LabVIEW Embedded for ARM Tier 1 boards are development boards that work with LabVIEW out-of-the-box.)

Don't wait for National Instruments to do this. It needs to be done by Texas Instruments. There's a great opportunity to make TI Stellaris very easy - even easier than the Arduino method. Tier 1 ports only take a couple of months to develop and will open up a whole new market for TI.

Message to Texas Instruments marketing - Create a couple of LabVIEW Embedded for ARM Tier 1 ports and see the popularity of those boards soar.