TI E2E Community
The Energy Required for Your Thing Just got Lower…Much Lower
Providing the ‘Energy of Things’ to the ‘Internet of Things’ is difficult. With so many Things around your home or office or car, no one power source can be used for each of them. Some can be plugged into the wall, others need to run off of batteries, and still others are not suitable for either of those power sources—these should harvest energy from the surrounding environment’s sunshine, wind, or vibrations. But with all of these different power types comes one overarching need—efficiency. With so many Things to connect together, very little power should be consumed by them. And what is consumed shouldn’t be wasted and given off as heat. The low and efficient power consumption of these devices is what unites them together.
A primary measure of the low power efficiency of a power supply is its quiescent current (Iq). While the Iq of a device is not the full story of the current consumed for a low power system (as I explain here), it is an easy way to compare the low power performance of different power supply devices. And when one particular device has an Iq that is roughly one-hundred times less than similar devices, it’s probably worth looking at how this affects the low power efficiency in more detail.
Texas Instruments’ DCS-Control power save mode topology has been leading the low power revolution for many years. Higher power DCS-Control devices, such as the TPS62130 and TPS62085, are needed to power the gateways/routers and servers. These devices can supply the higher power needed as well as achieve very high efficiencies at reasonably low output powers.
To power the very small and very low power nodes in the Internet of Things, even higher efficiency is needed. When paired with ultra-low power circuits in the latest devices, DCS-Control results in an unbelievably efficient combination. For instance, on the figure above, the far left point on the x-axis denotes 1 µA of load current, where the new ultra-low power TPS62740 provides 60% efficiency. And if the leakage currents or hibernate mode current consumption of your system draw just 10-µA, then 90% efficiency is achieved. For the nodes in your system, the TPS62740 is sure to make the most efficient use of this energy to power your Thing to enable the Internet of Things in your life.
What "things" are you powering with ultra-low power?
To learn more about how TI connects more to the IoT check out these other IoTWeek blog posts:
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.