Could somebody tell me how do I able to program the McBsp from the DSP (64x+) of the OMAP3530?
I am using CCS 3.3 on evm3530 and would like to program the McBsp2 from the DSP. Even after I setup the TLB from the arm side (see below) using the gel file, I am still not able to access the McBsp registers from the DSP side.
*(int*)0x5D000050 = 0x00000000; *(int*)0x5D000058 = 0x4902200E; *(int*)0x5D00005C = 0x49022140; *(int*)0x5D000054 = 0x00000001;
Thanks
Stephen
Reviewing the OMAP3530 Technical Reference Manual (SPRUF98) in Table 1-5 would tell me the McBSP2 is at address 0x49022000 at the base.
Brandon
ALL CONTENT AND MATERIALS ON THIS SITE ARE PROVIDED "AS IS". TI AND ITS RESPECTIVE SUPPLIERS MAKE NO REPRESENTATIONS ABOUT THE SUITABILITY OF THESE MATERIALS FOR ANY PURPOSE AND DISCLAIM ALL WARRANTIES AND CONDITIONS WITH REGARD TO THESE MATERIALS, INCLUDING BUT NOT LIMITED TO, ALL IMPLIED WARRANTIES AND CONDITIONS OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, TITLE AND NON-INFRINGEMENT OF ANY THIRD PARTY INTELLECTUAL PROPERTY RIGHT. NO LICENSE, EITHER EXPRESS OR IMPLIED, BY ESTOPPEL OR OTHERWISE, IS GRANTED BY TI. USE OF THE INFORMATION ON THIS SITE MAY REQUIRE A LICENSE FROM A THIRD PARTY, OR A LICENSE FROM TI.
Content on this site may contain or be subject to specific guidelines or limitations on use. All postings and use of the content on this site are subject to the Terms of Use of the site; third parties using this content agree to abide by any limitations or guidelines and to comply with the Terms of Use of this site. TI and its suppliers reserve the right to make corrections, deletions, modifications, enhancements, improvements and other changes to the content and materials, its products, programs and services at any time or to move or discontinue any content, products, programs, or services without notice.