Looking for Pre amp for our microphone (ECM) application.
The TLV1012,a low cost solution look interest, but it seems to be used only inside a microphones.
Is it correct,?can it be used with d/a?
Let me see if I can round up someone on this...
Audio Applications Engineering Manager
Dallas, TX USA
The TLV1012 has no VCC pin, the output and VCC are the same pin. This is ideal for a two wire microphone cable.
However, it can be used outside a microphone to amplify audio signals.
Regards,Ronald MichallickLinear Applications
TI assumes no liability for applications assistance or customer product design. Customer is fully responsible for all design decisions and engineering with regard to its products, including decisions relating to application of TI products. By providing technical information, TI does not intend to offer or provide engineering services or advice concerning Customer's design. If Customer desires engineering services, the Customer should rely on its retained employees and consultants and/or procure engineering services from a licensed professional engineer (LPE).
In reply to Ron Michallick:
Yes, it can amplify a microphone signal with the output connected to a D/A.
We're using the TLV 1012 as a pre amplifier for our MIC input. We're facing a specific noise coupled to Pre amplifier output whenever Wi-fi enabled. In data sheet , it has suggested to connect 10pf & 33pf on Pre amplifier o/p for avoiding noise due to GSM signal (980, 1800/1900 MHz). Similarly can i use some capacitor to avoid Wi-fi specific noise (2400 MHz)? what should be the capacitor value? can you please guide me on this issue?
Thanks & regards,
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.