TAS5132 PBTL application

na na78

Guru 16770 points

Other Parts Discussed in Thread: TAS5132, TAS5352A, TAS5342LA

We want to design PBTL application in TAS5132, but we can't find PBTL application design in TAS5132 datasheet.

Can you show us recommendation of PBTL design for TAS5132?

BestRegards

over 7 years ago

0 Diego Melendez over 7 years ago

TI__Guru 57800 points

Hi, Na,

I have asked my colleague to take a look to your question, as today is a Holiday in the US, he will be able to get back to you tomorrow.

Best Regards,

-Diego Meléndez López
Audio Applications Engineer

0 Matthew Beardsworth over 7 years ago in reply to Diego Melendez

TI__Genius 9175 points

Hello Na,

1. PBTL is selected using the mode pins as shown below. Note that only PWM A is used in PBTL.

2. For the outputs, A B C and D should each have separate filter inductors. After the inductors, outputs A and B should be tied together and connect across one side of the load and outputs C and D and should be tied together and connected across the other side of the load.

3. The TAS5352A datasheet shows the basic PBTL configuration however as mentioned above with the TAS5132, only "1N" mode (input A only) PBTL is supported.

4. You can test the PBTL configuration using the TAS5132 EVM.

Best Regards,

Matt

0 na na78 over 7 years ago in reply to Matthew Beardsworth

Guru 16770 points

Hi matthew

Thank you for your reply.
TAS5132 can be used for BD modulation in PBTL and BTL?

BestRegards

0 Matthew Beardsworth over 7 years ago in reply to na na78

TI__Genius 9175 points

Hello,

Only AD modulation can be used in PBTL. In BTL both AD and BD are supported.

Best Regards,

Matt

0 na na78 over 7 years ago in reply to Matthew Beardsworth

Guru 16770 points

Hi Matthew

Thank you for your reply.

Do you have a recommended solution instead of TAS5132?

For example, TAS5342LA can be used with BD modulation in PBTL/BTL?

BestRegards

Audio

Audio forum

TAS5132 PBTL application