Hi,
I understand that RXIN0 and RXIN1 should be connected to GND when coaxial inputs are not used and VDDRX is not supplied. The reasons are the below threads.
https://e2e.ti.com/support/amplifiers/audio_amplifiers/f/6/t/590264
https://e2e.ti.com/support/data_converters/audio_converters/f/64/t/329626
However, our customer found in Table 1 of datasheet page 20 that coaxial input-pin outputs 'H' during reset. I doubt that RXIN0 and RXIN1 belong to normal digital input. Please tell us the behavior of RXIN0 and RXIN1 when VDDRX is not supplied and /RST pin is 'L'.
Best regards,
Akio Ito