Part Number: LM5056A
I have got incorrect readings for temperature and voltage measurements. I found out that I have got incorrect VREF voltage on pin 15 of LM5056A . I measured VREF and got 4.1 V which is much higher than 3V (max) as per datasheet. I have got ceramic cap 1uF, 6V placed next to the pin.
I understand that VREF is an internal reference voltage which is generated precisely 2.97V. I would like to know what could cause my VREF higher than expected value.
Looking forward to your reply.
Hey John, You're right that you should not be seeing 4.1V at Vref pin. Could you send us the schematic for how your are configuring the device? Also, are you able to get correct input voltage or readings? Or is the Vref affecting this? If you have any package or lot information please send this information as well. Sincerely, Peter Iliya Current Sensing
In reply to Peter Iliya:
Thanks for your reply. At this moment I am using this chip to measure input voltage and Temperature only. I preserve current and power measurement for next generation of our products. My theory on your chip is : there must be current threshold for the chip's Vref internal regulator in order to get correct voltage range. I have experience on other TI chips about current through REF pin got influence on the voltage of VREF. At this point of time I just put 3.9k at Vref pin to gnd in parallel with ceramic cap 1uF that draws around 0.75 to 1 mA from Vref. After putting this resistor, I got my Vref 2.97V and my input voltage and temperature readings are correct.
I just want to know would there be any side effect for doing this configuration. Please correct me if my theory is wrong and advise me better solution for my case. Is there any issue for this chip if I leave these pins [pin1 (OUT), pin 3 (SENSE) & Pin 4 (VIN_K)] open. Kindly let me know your opinion.
In reply to John Lwin:
Yes, it does even after replacing new LM5056A chip. If this configuration is not affecting chip's performance, it is good for now. Thanks.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.