This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Part Number: LM339
I am using an LM339 in conjunction with a 4401 transistor to control a FET.
I have started to see a rash of FET failures and have been able to make the circuit work and/or fail by changing the LM339.
The part markings on all the sample assemblies that fail are 'TI LM339' and 'HYC5392H'.
The markings on the sample assemblies that work are a mixture:
LM339 G4 and 9CADSVM
LM339 and 16P18NAG4
LM339 and 05P042AG3
LM339 G4 and 04ALFDM
What has changed?
Can you provide the exact part number you are ordering (Assuming LM339D or PW).
Can you also provide a schematic that shows both the input signal source and output loads? What is the FET driving?
Low Power Amplifiers and Comparators (LPAC) Applications
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
In reply to Paul Grohe:
My parts list calls out LM339D.
I inserted a pdf of the schematic, but I don't think it worked properly. If not is there a convenient way to send you a pdf?
P1-2: Analog input creates xx% duty cycle at FET (above 9v = 100%, below 1v = 0%)
Failing output is connected to a solenoid.
In reply to Brian Mix:
The LM339 does not get damaged. Q2 overheats and fails (open). We can monitor and see the temperatures start to rise and shut down before failure occurs. We use this method to stop running before failure and then change the LM339. We can make a good assembly fail, and a failing assembly good, by swapping the LM339.These assemblies are built for us by Global Point in China, getting pic's of the reel may be difficult.Picture of top of failing LM339, blow-up of TI Logo, and bottom of IC attached.
It is OK to contact me directly via my email.
You have come to the same conclusions that we have. The "bad" LM339 is causing the FET to switch many times each time it should switch once. I can make the changes and tests you suggest, but we get the same results removing these parts would give by setting the input above 9v. At this input, the LM339 sees only one transition on its inputs so the FET comes on and stays on. In this configuration (as long as the load is small enough for the FET to run 100% duty cycle) the boards will run OK.
I will contact you directly.
Thanks for all your help, Paul.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.