This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

  • Resolved

XTR115

Hi,

I am using XTR115 in my application.I want to use XTR115 with PWM (Isolation required) and as current source.Can i go with XTR115?

  • Hi Amruta,

    like shown in figure 3 of datasheet?

    Kai
  • Hi Amruta,

    You could certainly use the XTR115. Once you have your design if you'd like to post it here we can look it over.

    Regards,

    Zak Kaye
    Precision Amplifiers Applications 

  • In reply to Zak Kaye:

    Hi zak ,

    I had done with design but i can not post schematic in forum. Can you please give me your mail id so I will communicate with you.

    Thank you.

  • In reply to Amruta Bhujbal67:

    You can reach me at zakkaye@ti.com

    Regards,

    Zak Kaye
    Precision Amplifiers Applications 

  • In reply to Zak Kaye:

    Amruta

    We haven't heard back from you so we assume you were able to resolve your issue. If not, post another reply below.

    Thanks
    Dennis
  • In reply to Dennis Goeke:

    Hi,
    Still I am not done with practical.Very soon complete it and I have any doubt then i will post it
    Thank you.
  • In reply to Amruta Bhujbal67:

    Amruta

    I'm going to close this thread, but once you get your circuit completed if you have any more questions you can reopen it by posting another reply below.

    Thanks
    Dennis
  • In reply to Dennis Goeke:

    HI,

    Thank you so much zak.I had complete design and got correct result.

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.