I'm using the pga309evm-usb after I had problems with the pga309evm without usb. This evm looks far more professional the the predecessor but i'm facing some problems.
I have connected a full bridge sensor end setup all the jumpers to ext mode for the external bridge. If I want to change the gain in the block diagram the green light ("Pending changes need to be written") lights up and after "Write all reg" the change is active. But if I want to change the zera dac, gain dac or mux then the green light does not light up. I also see no activity on the PRG1 pin if I do "Write all regs". What might be wrong?
Thanks in advance,
I got new software from TI (Arthur Kay). Every thing works fine now. It is exactly working as expected. It's a very good tool.
All problems are solved now.
I have the same problems, what's the latest software from TI?
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.