This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Does anyone have any suggestions for this thread:
I didn't know how to move it over to the Precision Amplifiers folder.
Basically, I have a high side current shunt on a 12V battery that should give me between +/- 5mV of voltage drop when the load current flows. I hooked everything up as shown in Figure 1 of the data sheet. I use 100k resistors for both Ros and RL, which should give me a gain of 100. I have 3.3 V supply for V+, and am providing a 1.5V Vref using the wiper of a 10k variable resistor.
The first problem is that the Vref voltage doesn't seem to have any effect on the output voltage. In fact, the voltage at the Vref pin measures 12V (even though I have connected a 1.5 V reference as explained earlier, the chip is feeding power through the pot). Secondly, when the shunt voltage changes even slightly, the output voltage immediately up past the 3.3V rail to around 6 V. How is this happening? I have tried three different chips and they all do the same thing. Note that I have used a MSOP8 to DIP adapter and currently have everything breadboarded.
Thanks in advance.
Hello Mark,Thank you for considering the INA170 for your application.I set up a similar circuit to yours but did not observe the issues you are observing. The circuit was slightly different due to equipment limitations. Here was my setup:Vcm=10VVsense=100mVpp @ 100HzV+=3.3VVref=1.5V (adjusted down to 1.3V due to clipping...most likely due to device and equipment errors)Ros=RL=10k 1% discrete (Gain=10)Therefore I have the following recommendations:a) Try replacing the potentiometer with a fixed resistor and/or apply the Vref voltage directly to the pin of the deviceb) Try using a different location on your breadboardc) Since you measured an output voltage of 6V given V+=3.3V, I would sample new devices for these modified measurements.Finally, I would also like to point out that the offset voltage of the INA170 (+/-1mV) can introduce up to 20% error on a +/-5mV sense voltage. You may be interested in a lower offset voltage device such as our INA21X family. If you use the INA214 (G=100V/V, Vos=+/-60uV) this error would be reduced to 1.2%. I hope this helps.
General Purpose Amplifier Applications
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
In reply to Pete%20Semig:
for the INA170 If I do not need an Offset Resistor on PIN 5, can I just leave that pin open?
In reply to Jehanzaib Karim:
The Ros pin is used in conjunction with Vref pin to bias the output for bi-directional operation, so I'm not sure why it's not being used. For unidirectional operation perhaps you'd be interestd in the INA169 instead.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.