This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Part Number: TL441
I am trying to build a lock-in amplifier. This amplifier needs to operate at 3.58MHz, sine wave. I use TL441 as the logarithmic amplifier, TL592B as the linear amplifier, then the reference signal and the test signal input into the multiplier AD734. Because the tested signal is too low, I have to use two levels of amplifiers. However, after passing through TL441, the AC component in the tested signal was lost. Can any TI Specialist or any friend in E2E community provide any advice on solving this issue? Or TL441 cannot be applied to this range of frequency.
Thank you in advance,
A TI user
Precision Amplifier Applications - TI Tucson
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
In reply to Alexander Davis:
Sorry for the late reply. I need to check with my advisor to allow me to share our schematics. The chip (IC3) with 16 PIN is TL441. The chip (IC1) with 8 PIN is TL592, and the one (IC2) with 14 PIN is AD734.
At the bottom of the board are three BNC connectors. "signal rec" means the signal from the receiver. "rf gen" means the signal from the radio frequency generator. "transs antenna" means the connector to the transmission antenna.
In reply to Jundong Chen:
Please repeat your measurements with an oscilloscope, not a handheld DMM. A DMM will not accurately measure AC voltages above a few hundred kilohertz. An oscilloscope will also indicate if there is any unusual clipping, oscillation, distortion, or noise present, which a DMM measurement absolutely will not.
I sketched out your schematic, and it looks alright. Given that the TL441 and TL592B portion comes from the TL441 datasheet, I wouldn't expect any major issues. One thing that I do find concerning was your measured voltages at the +IN and -IN pins of the TL441. Under normal operation, I'd expect those to be very close to the same voltage. The fact that you're seeing IN+ = 2.55, IN- = 4.78 suggests that something isn't right there. Given those input values, I'd expect IC1 pin 4 to be -4 volts or so.
You may also want to tweak your layout a little. While 3.85MHz isn't terribly high frequency, and won't cause layout issues from that perspective, a smaller, more direct layout that minimizes signal loop areas, uses a ground plane, and places power supply capacitors near the devices they're powering should perform better in general, and particularly be less sensitive to noise and external interference.
These two articles cover some of the basics of layout, although some of the topics they cover won't necessarily apply to your design.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.