XTR115

Amruta Bhujbal67

Other Parts Discussed in Thread: XTR115

Hi,

I am using XTR115 in my application.I want to use XTR115 with PWM (Isolation required) and as current source.Can i go with XTR115?

over 5 years ago

0 kai klaas69 over 5 years ago

Guru 140200 points

Hi Amruta,

like shown in figure 3 of datasheet?

Kai

0 Zak Kaye over 5 years ago

TI__Mastermind 23050 points

Hi Amruta,

You could certainly use the XTR115. Once you have your design if you'd like to post it here we can look it over.

0 Amruta Bhujbal67 over 5 years ago in reply to Zak Kaye

Intellectual 390 points

Hi zak ,

I had done with design but i can not post schematic in forum. Can you please give me your mail id so I will communicate with you.

Thank you.

0 Zak Kaye over 5 years ago in reply to Amruta Bhujbal67

TI__Mastermind 23050 points

You can reach me at zakkaye@ti.com

0 Dennis Goeke over 5 years ago in reply to Zak Kaye

TI__Genius 11135 points

Amruta

We haven't heard back from you so we assume you were able to resolve your issue. If not, post another reply below.

Thanks
Dennis

0 Amruta Bhujbal67 over 5 years ago in reply to Dennis Goeke

Intellectual 390 points

Hi,
Still I am not done with practical.Very soon complete it and I have any doubt then i will post it
Thank you.

0 Dennis Goeke over 5 years ago in reply to Amruta Bhujbal67

TI__Genius 11135 points

Amruta

I'm going to close this thread, but once you get your circuit completed if you have any more questions you can reopen it by posting another reply below.

Thanks
Dennis

0 Amruta Bhujbal67 over 5 years ago in reply to Dennis Goeke

Intellectual 390 points

HI,

Thank you so much zak.I had complete design and got correct result.

Amplifiers

Amplifiers forum

XTR115