This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Many postings in the E2E Forum can be designated as a Frequently Asked Question or FAQ. In order for you to quickly create a system and implement a current and power sensing solution here is a curation of links to these FAQ postings. As time goes on more public postings can be designated as a FAQ and thus may not be listed here, but can be searched in this forum.
What are the input bias current and input impedance specifications for bus voltage monitors?
How do I know the output swing of current sense amplifiers or OPAs in general?
Bandwidth considerations for measuring PWM signals specifically with INA240.
Why can I exceed the absolute maximum voltage rating if I limit the input current?
What are some ways to protect a current sensor and prevent its input voltage from exceeding -0.3V absolute max rating?
Considerations for adding TVS protection diodes
System level considerations:
Choosing pull-up resistor for an I2C bus.
What are power sequencing considerations for current sense amplifiers?
What is the closed-loop output impedance (ZOUT) of a current sensor and how can I compensate this output for capacitive load stability?
How do external resistors on a reference pin affect CMRR and gain error for current sense amplifiers?
What are the critical error sources for measuring small current levels?
What are other ways of using high-side current sensors such as INA3221 and INA219?
How to use the power accumulator in current sensing, specifically for the INA233
Measuring 20mV Vsense with INA193, INA194, INA195, INA196, INA197, INA198, INA270, or INA271
Can the internal-shunt INA250 be used in-line with a PWM signal?
User’s Guide for INA250EVM with just one A2 device
Explaining the datasheet plots for INA199 and its A1, A2, and A3 versions.
Difference between INA199A, INA199B, and INA199C devices
Difference between INA21xA, INA21xB, and INA21xC devices
Layout recommendations for internal shunt current sensing using devices such as INA250 or INA260
To learn more about TI E2E, please visit e2e.ti.com/.../helpcentral
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.