We are using THS6182.
As you can see on the schematic, the THS6182 is powered in +- 12V and Bias2 is always to 3v.
When we put Bias1 to 0v, amplifier is ON, in low bias mode (cf datasheet).
But, when we put Bias1 to 3.2v, the amplifier is still running instead of sleep mode.
In the screenshot below : pink is Vin1 and blue is gate Q3, with THS6182_ON/ = 3.2V
Do you have any idea of what can happened?
Thanks and regards,
The first thing I notice is that there is a voltage divider connected to Bias2. This would drop the voltage at the pin from 3.3V to 2.7V. From the datasheet, the threshold voltage for both Bias-1 and Bias-2 to be on is 3.3V. I would try replacing R226 with a short and verify that there is 3.3V on both Bias-2 and Bias-1 for the proper shutdown condition.
Let me know if this fixes the problem.
The THS6182 worked properly, but U12B (inversion stage) will transmit the signal through R50 and R53 to output. All wery simply.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.