TINA/Spice/VCA810: Simulation with AC input sweep(AC10mV -> AC100mV)

Hirotaka Matsumoto

Part Number: VCA810
Other Parts Discussed in Thread: TINA-TI,

Tool/software: TINA-TI or Spice Models

Hi all

Would you mind if we ask TINA-TI simulation with VCA810?
Please refer to following file.
2656.20170808_VCA810_circuit.TSC

On this file, we would like to simulate with AC input(VG1) sweep(AC10mV -> AC100mV).
Is it possible to use it?
We could not find it this way.

Kind regards,

Hirotaka Matsumoto

over 6 years ago

0 Rohit Bhat over 6 years ago

TI__Genius 15975 points

Hi Hirotaka,

I believe it is possible to simulate with AC input sweep from 10mV --> 100mV in TINA-TI.

For sweeping a parameter, you need to go to Analysis ---> Mode ---> Parameter Setting and choose either Combinational or Parallel stepping. Then follow the instructions given below for the Parameter Stepping in the below image.

Best Regards,

Rohit

0 Hirotaka Matsumoto over 6 years ago in reply to Rohit Bhat

Guru 27525 points

Robit san

Thank you for your reply.
OK, we got it.

Kind regards,

Hirotaka Matsumoto

Amplifiers

Amplifiers forum

TINA/Spice/VCA810: Simulation with AC input sweep(AC10mV -> AC100mV)