TI E2E Community
Precision Amplifiers Forum
About microphone IC product
We are working on the microphone input chain on the MSP430f5438 expermenter board, whose schematic is showed below.
We simulated it in Multisim and it showed a cutoff frequency of around 4kHz for the low-pass filter. But for our application, we need that to be more than 10kHz. Since we have many same boards need this modification, I would like to ask if there is any commercial IC product available for this. Maybe something similar to the following circuit (I saw it from another one's post in this forum).
The op amp you are using does not have a sufficient gain-bandwidth product to provide a gain of 240 with a bandwidth of 10kHz. The gain * bandwidth of the TLV2760 is only 500kHz. The gain * bandwidth of your circuit is approximately 2.5MHz. An op amp with a gain-bandwidth of 5MHz or so would probably give you reasonable results.
An alternative is to break the gain into two stages of approximately 15 each. In this case, the TLV2760 would be sufficient.
Thank you for replying. Could you give me a hint about which op-amp we should propably use for our application?
And is there something commercial available which contains the circuit with suitable op-amp? Since we have a lot of boards need modification.
Regards and Thank you,
I recommend the OPA314 with 3MHz gain-bandwidth. I am not aware of any special purpose device for this function. I recommend using an op amp.
Thank you very much!!
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.