TL3474 - the diode for Clamp

Hirotaka Matsumoto

Other Parts Discussed in Thread: TL3474

Hi all,

Would you mind if we ask TL3474?

We contributed the question about the internal diode for voltage clamp as following;
https://e2e.ti.com/support/amplifiers/precision_amplifiers/f/14/p/412744/1466014

We would like to confirm followings again;
-TL3474 input pins have diodes to VCC-/GND supply.
-Therefore, the diode should not be needed.

Is our recognition correct?

Kind regards,

Hirotaka Matsumoto

over 9 years ago

0 Ron Michallick over 9 years ago

TI__Guru*** 140106 points

Hirotaka-san,

Input diode usage depends on the application.
What is the expected input input voltage range?

0 Hirotaka Matsumoto over 9 years ago in reply to Ron Michallick

Guru 27525 points

Ron san,

Thank you for your reply.

TL3474 connects to shunt resistor for current sensing.
So, by current swtiching, surge voltage occurs rapidly.
The value will be ±1V.
(Vcc=12V, Vcc-=0, single supply)
We guess that in case of Vin=-1V, it is reguired inputs diodes.
Is our recognition correct?

Kind regards,

Hirotaka Matsumoto

0 Ron Michallick over 9 years ago in reply to Hirotaka Matsumoto

TI__Guru*** 140106 points

Hirotaka-san,

Yes, diodes are recommended. I also suggest low pass filter to limit transients so that TL3474 responds to current level and not transient noise on the switching edges.

0 Hirotaka Matsumoto over 9 years ago in reply to Ron Michallick

Guru 27525 points

Ron san,

Thank you for your prompt reply!

Kind regards,

Hirotaka Matsumoto

Amplifiers

Amplifiers forum

TL3474 - the diode for Clamp