ECG

Francisco Garay

Good afternoon

My name is Francisco Garay, I build a ecg analog circuit and with an USB-6009 NI I capture and convert in digital signal ECG. Next via Matlab using wavelet discret I denoise interference 60Hz, baseline wandering and noise gaussian. Now I want to work in real time with DSP TI, Please you could help me to tell me who is the module of evaluation family C6xxx for to make this project.

Thank you very much for your response

over 5 years ago

0 dzhou over 5 years ago

TI__Genius 9065 points

Francisco,

Have you looked into TMS320C667x DSPs? C6671 has one DSP, C6672 had two DSP, C6678 has 8 DSPS.

best regards,
David Zhou

0 Francisco Garay over 5 years ago in reply to dzhou

Prodigy 90 points

Please one question...

If I have one electronic card with interface SPI, is possible to send data to SPI interface C667X for to process this data

0 dzhou over 5 years ago in reply to Francisco Garay

TI__Genius 9065 points

Francisco,

Yes, it is possible. It all depends on the amount of data that you need to pass through SPI as it will be limited by the SPI bandwidth.

On C667x devices, there is a lot of high speed interfaces such as SRIO, PCIe, Hyperlink, Gigabit Ethernet available. You can choose to use for large amount of data if needed. Throughput document for these peripheral are here:
www.ti.com/.../sprabk5b.pdf

best regards,
David Zhou

Data converters

Data converters forum

ECG