This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Part Number: AM3358
Tool/software: Code Composer Studio
I have developed a Code Composer Studio aplication for BeagleBone Black that gets data from a Flir Boson camera and transmits the data via ethernet
I now want to add SD card write and read to the project.
I found an example project in starterware - C:\ti \AM335X_StarterWare_02_00_01_01\examples\beaglebone\hs_mmcsd - and started to merge the code.
When I compile, I get these errors....
unresolved symbol HSMMCSDModuleClkConfig, first referenced in ./Demo_Sources/main.obj snmp_agent_demo C/C++ Problemunresolved symbol HSMMCSDPinMuxSetup, first referenced in ./Demo_Sources/main.obj snmp_agent_demo C/C++ Problem
..... even though they are referenced in #include "beaglebone_black.h"
Two other calls....
/* Configure the EDMA clocks. */ EDMAModuleClkConfig();
/* Configure EDMA to service the HSMMCSD events. */ HSMMCSDEdmaInit();
Can any one put me straight on this? What am I missing?
Thanks in advance
In reply to Lalindra Jayatilleke:
When I downloaded the AM335x Processor SDK RTOS and followed the instructions issued, I did not get the
I did get......C:\ti\pdk_am335x_1_0_9\packages\ti\starterware\examples\
The nearest software I found was..........
Have I missed a step?
In reply to steve robinson1:
Steve, Did you Run pdksetupenv.bat first as in the instructions? I don't see where you entered the subsequent flags to pdkprojectcreate.bat in your command. i.e pdkProjectCreate.bat [soc] [board] [endian] [module] [project type] [processor] Did you register your installed components with CCS? "Ensure all dependent/prerequisite products are installed and registered with CCS before proceeding with the examples and/or unit test. Starting CCS after installing the Processor SDK products will cause CCS to find and register any new products. Errors will occur during PDK project creation if any dependent products have not been registered with CCS." Lali
I managed to run the video in a different browser - OK now.
Thanks to this I discovered that I had missed an important step - CCS needs to process the new products before the 'myexample' projects can be generated.
These projects are now generated and I can open them in CCS.
However, I cannot open the c source files in CCS - I get a
"Must specify a URI scheme:PDK_INSTALL_PATH/ti/drv/uart/soc/am335x/UART_soc.c" message for each.
I don't know what a URI scheme is, I'm afraid.
I guess this is a CCS/Eclipse issue. I have been, and will continue to do so, googling for a solution.
If you could put me right on this quickly, I would be most grateful.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.