This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Part Number: TLV320AIC3256
Tool/software: Code Composer Studio
I'm working with the TLV320AIC3256EVM-U and the PurePath Studio for its programing.
I could program and work with the LINE INPUT, USB - Audio EVM through the component inputs, DEC1,2,..., I2S-IN, MONOI2S and MONO DEC. Always from the PC or from some device through the Line Input; but; I can't introduce any sound from the Microphone Input. I used microphones from the headset, electrelect, semi profesional but nothing occurs.
Could someone of the colleagues borrow me a schematic in .pfw to try or give me clue about what it's occurring.
Looking forward to hearing from you soon, best regards
In reply to Diego Melendez:
Hola Diego; Feliz Año Nuevo!!!
Regarding about the mic problems, it's sure it would be produced by the low biasing in the AIC3256; could you Please give us directions how to change the register R51 to deliver 2.5 volts as bias?
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
In reply to Daniel Alayon:
In order to configure the micbias of the 'AIC3256 as 2.5V, Page 1: Register 51 bits D5 and D4 should be set to "11".
2.5V will be the micbias voltage with this configuration as long as the full Chip Common mode is set as 0.9V (Page 1: Register 10, Bit D6).
-Diego Meléndez López Audio Applications Engineer
Hi Diego, same for you!!!
Then in Register 51, Page 1 it would be filled with 0x30 and for Register 10 at Page 1 it would be 0x40, that's right?
For register 51, 0x30 will set the micbias as 2.5V, however, you also need to turn micbias ON. So the correct value to turn micbias ON and set it as 2.5V for Page 1: Register 51 is 0x70. Please note that this assumes that micbias is generated from AVDD (bit D3 = 0).
Page 1: Register 10, Bit D6 should be 0 to set the common mode voltage as 0.9V, so the correct value should be 0x00
A lot of thanks Amigo
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.