CDCI6214EVM: What are the jumper part numbers?

John,

My experience with these jumpers is that they are interchangable provided the pitch is correct.
I don't konw about this CDC board, but for LMX boards we use

TE Connectivity
881545-2


Regards,
Dean

Dean,

I appreciate the reply and might expect the 0.1" pitch headers to be a 235 mil "standard" post height but the 0.05" pitch is much more difficult to find standards for.

I'd love to at least see post length for the pins I hope to connect to an external programming header so I can verify the insertion depth is adequate.  I may need to just solder to the development board instead because the 50 mil headers are difficult, particularly when the inside pins are spaced about 2.2mm apart: too wide for a 2.0mm header and not near an integer of 50 mil.  Most wire-to-board sockets at this pitch tend to have added width which would not let me plug two 2-pin connectors next to each other.  Finding a good single pin crimp connector to use alone instead of in a housed socket meant knowing the pin length, assuming 0.40-0.46mm square posts.

I might be able to wire to board-mount sockets that would allow both adjacent 2-pin headers to be accessed but it sure would have been nice to just use proper connectors.

What would have really helped is having a dedicated programmer available for the CDCI6214.

Sincerely,

John Handwork