This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Part Number: ADC12DJ3200EVM
My customer test the ADC12DJ3200EVM, they measured the noise power density by terminating the input with 50ohm. Then got results like -80dBFs/4.5MHz i.e -147.1dBFs/Hz. But as per Data Sheet -151.8dBFs/Hz should come. Can what could be the reason for this 4dB Delta?
Waiting for your reply
Attached the error screen shot.
What is the minimum sampling freq I can use in ADC GUI. Why asking this question means when I went to 800 MSPs and JMODE0 with DDC gain boost on and cal trigger running on .I am getting error while capturing the data. Similarly can you tell me minimum sampling frequency with highest decimation factor.
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
In reply to Star Xu:
In reply to Brian2001:
It is possible to operate with Decimate by 16 and 800 MHz clock rate, using JMODE15.
Lane rate limitations of the TSW14J57EVM capture firmware limit the minimum clock rate to higher minimum frequencies and lower maximum frequencies for specific JMODEs. The current supported lane rate range is from approximately 3.2 Gbit/sec to 12.8 Gbit/sec. The lane rate for a given JMODE and CLK frequency can be calculated using the R parameter in Table 18 in the ADC12DJ3200 datasheet.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.