This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Part Number: PGA411Q1EVM
I am trying to connect the PGA411-Q1 EVM to the PGA41x-Q1 EVM GUI and there are a couple of things that I cannot seem to make it work. First, when I plug in the USB cable to my computer, the USB_RDY LED is constantly in a blinking state (I power on the device with 5VDC before I plug in the USB). There are random times when I can get the LED to stay solid, but when I do, the next problem happens; the GUI usually reads "Connection Status: connected" and "PGA41x-Q1 Device: Not Available." Based on the user manual, this makes me seems like the board isn't connecting. Every once in a while (totally random set of circumstances) the board will connect, and I get a status of "PGA41x-Q1 Device: Revision V111,11," which seems slightly odd. What can I do to make this work?
On top of that, when I probe the across the OE1 and OE2 pins, I don't see any excitation frequency.
If you have any advice, I would really appreciate it.
There is a trick to the EVM.
You should be seeing Revision v11.1 for the "PGA41x-Q1 Device" and 220.127.116.11 for the "USB Firmware" field.
If you don't have a resolver sensor connected, then the PGA411 will report a fault condition and you will not see anything on OE1 and OE2. Try holding the FAULTRES button on the EVM while monitoring OE1/OE2. Once you have the GUI working, you can also control the FAULTRES pin from the main page or the "Pin Configurations" page.
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
In reply to Clancy Soehren:
What a trick! I'll give this a shot and report back. Just to be clear, if I don't have the resolver connected, I can hold the FAULTRES button and I should see the excitation frequency across OE1/OE2?
Side question: What current should the EVM board be drawing? I notice that the PGA411-Q1 chip immediately gets hot to the touch when I connect it to 5VDC. The board draws 0.98 Amps from my supply (seems high).
In reply to Manuel Ahumada:
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.