CCS/TSW1400EVM: MMwave studio does not run, matlab engine could not be started

Hi Jopaul,

I've asked an expert to look into this and we should have an answer for you in the next few days.

Cheers,

Akash

HI, Jopaul:

Are you using the newest radar studio 2.1.0.0?

http://software-dl.ti.com/ra-processors/esd/MMWAVE-STUDIO/latest/index_FDS.html

In users guide section 2.1, it provides a link to the 32 bit matlab runtime v8.5.1.  Can you make sure you are using that?

C:\ti\mmwave_studio_02_01_00_00\docs\mmwave_studio_user_guide.pdf 

Best,

Zigang

It is been several days, please let me know whether you are able to solve your problem.  

Best,

Zigang

Sorry for the late reply , but yes im using the latest version 2.01 of mmwave studio wave . Can u let me know if there is any jumper connections that i have to in the TSW1400 or AWR1642 to solve the spi connectivity issue.

Thank you

HI, 

The MATLAB run-time engine should be able to run without hardware connected.  So it is not a jumper issue. Can you double check whether you have a 32 bit run-time engine or 64 bit run-time engine?  Can you follow the link in the document to install the run-time engine?

Best,

Zigang

Bro the matlab problem is successfully solved right now , but now when i run the mmwave studio i cannot get spi connectivity. Although i have loaded bss and mss , and even after I press spi connect button it shows disconnected in red for spi.

HI, 

Now it is a good time to check the switch settings.  Please refer to the following thread.

https://e2e.ti.com/support/sensors/f/1023/t/846620

Best,

Zigang

BTW, how were you able to solve the MATLAB ISSUE?

Best,

Zigang

I downloaded the 32 bit version of matlab for the computer , this seemed to sovle the problem..

But How to sovle the spi connectivity issues...

Correct the switch setting as showed in the e2e thread I attached and re-open the radar studio and go over the procedure again.

Best,

Zigang

Hi sir , 

They have shown for DCA100 in it mine is TSW1400evm with AWR1642 , can i know which buttons to press for in it .. I have attached the borad photo here and my error shown in mmwave studio output..

 I will forward to an expert on this issue.  At the same time, you can read the document and check the hardware connections and jumper/switch settings.   

Best,

Zigang