Interface OMAP L138 LCDK with ADS1602 EVM using 5-6k interface platform

Yung YU

Other Parts Discussed in Thread: ADS1602, OMAP-L138

Dear Friends,

We would like to interface our OMAP L138 LCDK with ADS1602 EVM using 5-6k interface platform. Unfortunately, I cannot find any manual or examples. Do you have any example or suggestions regarding how we should approach this problem?

over 7 years ago

0 Tom Hendrick over 7 years ago

TI__Guru**** 168605 points

Hi Yung YU,

The OMAP-L138 Development Kit is not compatible with the 5-6K Interface board. That interface board was used with the older DSK series kits like the TMS320C6713DSK which had two 80-pin connectors that provided access to the serial ports and parallel data bus of the DSP. You would have to blue-wire the serial interface from the LCDK to the ADS1602EVM directly.

0 Sajad Rahmdel over 7 years ago in reply to Tom Hendrick

Expert 1705 points

Dear Tom,
Thank you for your prompt reply. I'm also a part of Prof. Yu's project.
Is there any tutorial on how to blue-wire the serial interface from the LCDK to the ADS1602EVM directly?
Please give us some advice on where to begin, any tutorial or document is highly appreciated.
Regards

0 Tom Hendrick over 7 years ago in reply to Sajad Rahmdel

TI__Guru**** 168605 points

Hi Sajad,

Please review my comments to your other post here:
e2e.ti.com/.../1954074

Data converters

Data converters forum

Interface OMAP L138 LCDK with ADS1602 EVM using 5-6k interface platform