FDC2114EVM: Connecting to LabVIEW?

Susan Lane

Prodigy 220 points

Part Number: FDC2114EVM

I would like to connect the output of the FDC2114EVM to LabVIEW. Is there a way I can do this?

over 5 years ago

0 Chris Oberhauser66 over 5 years ago

TI__Genius 14270 points

Hello Susan,

The EVM communicates with the GUI using a COM port through the USB connection. Labview can connect to COM ports and therefore communicate with the EVM. I will see if I can find a description of the protocol used.

Regards,

ChrisO

0 Susan Lane over 5 years ago in reply to Chris Oberhauser66

Prodigy 220 points

I have tried, however I seem unable to read data from the EVM.

0 Chris Oberhauser66 over 5 years ago in reply to Susan Lane

TI__Genius 14270 points

Hello Susan,

Without the protocol, you would not be able to configure or understand the responses from the EVM. I am trying to see if there is a document which describes the protocol.

Regards,

ChrisO

0 Susan Lane over 5 years ago in reply to Chris Oberhauser66

Prodigy 220 points

Did you find the document?

0 Vaibhav Garg10 over 5 years ago in reply to Susan Lane

TI__Intellectual 1020 points

Hi Susan,

Unfortunately support from TI for Labview to connect to our EVMs is not available. In reference to the document above, we we not able to find any related document.

I will be closing this thread. If you have any other questions, please ask a new question.

Regards,

Vaibhav

Data converters

Data converters forum

FDC2114EVM: Connecting to LabVIEW?