.ucf and verilog code for XC4VLX25 FPGA on the TSW1200EVM board

Brett Stroud

Other Parts Discussed in Thread: ADS5400EVM-CVAL, ADS5400

I would like to get .ucf (xilinx constraint file) and verilog source code for the XC4VLX25 FPGA on a TSW1200EVM board. I'm interfacing it with a ADS5400EVM-CVAL board and would like to write some custom code for the FPGA on the TSW1200EVM. My email is brett.stroud@ngc.com. Thanks.

over 10 years ago

0 Richard Prentice over 10 years ago

TI__Mastermind 29220 points

Sent to the address provided.

Regards,

Richard P.

0 Brett Stroud over 10 years ago in reply to Richard Prentice

Prodigy 20 points

The attachments didn't get through our company firewall. Can you please change the file extension to not be .zip or maybe better yet, send to this email addr instead: brettstroud@verizon.net. Thanks.

0 Richard Prentice over 10 years ago in reply to Brett Stroud

TI__Mastermind 29220 points

Sent to the alternate address.

Regards,

RIchard P.

0 AhEng Theng over 9 years ago in reply to Richard Prentice

Prodigy 30 points

Hi Richard,

I wish to request for .ucf (xilinx constraint file) and HDL source code for the XC4VLX25 FPGA on the TSW1200EVM board. I like to customize the HDL code for the FPGA on the TSW1200EVM to interface it with a ADS5400EVM-CVAL board. My email is taheng@dso.org.sg. Thank you.

0 Richard Prentice over 9 years ago in reply to AhEng Theng

TI__Mastermind 29220 points

Sent to the address provided. Note though that the TSW1200 (with the latest firmware which was revision 1.6) already supported the ADS5400 so no modification would be needed. And the -CVAL version of that EVM would also not need modification to the code. Form factor would be different but not data format. And further support for that version of the EVM would be better handled in the high reliability forum rather than this high speed data converter forum.

Regards,

Richard Prentice

Data converters

Data converters forum

.ucf and verilog code for XC4VLX25 FPGA on the TSW1200EVM board