DAC interface

prashanth tm

1) In one of our design we used DAC3283irgzt, below figure show the configuration how we used in our design,

2) Same DAC we are planning use in new design here we need to send the baseband, for this we need to remove the transformer.

below is the schematic for that, let me know if any modification required in this

over 8 years ago

0 Ebenezer Dwobeng over 8 years ago

TI__Genius 9695 points

Hi Prashanth,

Can you send the schematic file as an attachment? The resistor values at the output are hard to read.

Note that, the most important consideration is the output compliance voltage of the DAC is not exceeded. For maximum output swing at 20mA full scale current, the output common mode should be biased to 3.3V and the effective impedance should be 100ohms (differential) or 50ohms (single ended).

Thanks,

Eben.

0 prashanth tm over 8 years ago in reply to Ebenezer Dwobeng

Prodigy 60 points

Thank you, here i am attaching the schematic

DAC_SCH1.pdf

DAC_SCH2.pdf

Data converters

Data converters forum

DAC interface