CCS/MSP430I2021: How to use command line with CCS Uniflash V3.4 to Erase main memory only for msp430i2021

li Hong

Part Number: MSP430I2021
Other Parts Discussed in Thread: UNIFLASH, MSP-FET

Tool/software: Code Composer Studio

Hi ,

I want to flash msp430i2021,The programmer is MSP-FET,software is CCS Uniflash V3.4,I want to use command line to Erase main memory only,how to do?thank you!

over 5 years ago

0 Ki over 5 years ago

TI__Guru**** 420560 points

Hello,
Do you only want to erase memory without programming anything? If so, then this is not supported with UniFlash 3.x. You will have to use UniFlash 4.x if you wish to erase only without programming afterwards. You can always use the MSP Flasher tool also: www.ti.com/.../MSP430-FLASHER

Thanks
ki

0 li Hong over 5 years ago in reply to Ki

Prodigy 95 points

Hello KI,

I want to program and verify after erase main memory ,but not erase information memory,how to setup command line,if need to use uniflash v4.x?

0 Ki over 5 years ago in reply to li Hong

TI__Guru**** 420560 points

li Hong said:
I want to program and verify after erase main memory

This is no problem with 3.4. Example:

> uniflash -ccxml myTarget.ccxml -setOptions "MSP430DownloadOptions"="Erase main memory only" -program myProgram.out

0 li Hong over 5 years ago in reply to Ki

Prodigy 95 points

Hello,

got is ,thank you very much!

Code Composer Studio™︎

Code Composer Studio forum

CCS/MSP430I2021: How to use command line with CCS Uniflash V3.4 to Erase main memory only for msp430i2021