Tool/software: TINA-TI or Spice Models
Hello everyone!!!
I have a simulation problem with this circuit. I have tried many things, but I can not solve it
I modify the parameters,the analysis, but I can not simulate it
the version is TINA-TI 9.3.150
really, I appreciate your help
thanks...
this is the circuitConverter-DC-DC.TSC
Hi sake,
i appreciate your help
i also trying other solutions
This is the schematic: 2555.Converter-DC-DC.TSC
Hi Saket,
thank you very much for your help
I was also trying to simulate in other simulators,but not working.
If you need more information about the circuit,just tell me.
In tina simulated in "steady state solve" and to show me the next graphic ,where put the multimeter,at the circuit input that are 24 volts.
and his exit should be 160 V minimun.
Regards,
Luis.
Hi Luis,
I was able to run the published Pspice model's test bench in TINA and results are matching with PSpice model.
I found that your application setup is very similar to released Pspice model's test bench.
So, you can use the TINA schematic attached below to configure your application schematic.
Simulation Result:
Kindly let me know if you have any questions.
Once you re-configure your setup (with components used in attached tsc file)& still face convergence or any other issues then kindly let us know for further help.
Hope this will help you & really appreciate your patience!
Thanks & Regards,
Saket
