Tool/software: WEBENCH® Design Tools
Dear all,
Firstly, I am a graduate level student from Singapore and I am in charge of designing channel selection filters for low-IF transceiver systems.
I would like to design a low-pass analog filter using FilterPro software by TI, however, I am not able to enter any cut-off frequencies higher than 10MHz (10000000) on the software.
I need to design different filters with cut-off frequencies of 20MHz, 40MHz and 80MHz.
Is there any way to change the settings of the software or any other solutions you can suggest?
I am looking forward to hearing from you soon!
Sincerely,
Baris YILDIRIM