WEBENCH® Tools: Through Hole Only?

Anonymous

Guru 17045 points

Tool/software: WEBENCH® Design Tools

Is there a way to tell WEBENCH to use only parts with a through hole pacage?

over 6 years ago

0 Harish K R over 6 years ago

TI__Intellectual 2320 points

Hi Andy,

Thanks for reaching out to us. Currently there is no option in WEBENCH to use parts with "through hole" packages only.

Best Regards,

Harish

0 Anonymous over 6 years ago in reply to Harish K R

Guru 17045 points

I know this is a different question then the original heading, but can you tell WEBENCH to allow the circuit to have an in the original circuit an adjustable output i.e. probably via a potentiometer either manual or digital?

0 Atul_Kulkarni over 6 years ago in reply to Anonymous

Genius 4910 points

Hi Andy,

Currently we don't have option of potentiometer to vary the output. However you can vary the load manually in the schematic.

Regards,

Atul

Simulation, hardware & system design tools

Simulation, hardware & system design tools forum

WEBENCH® Tools: Through Hole Only?