TI E2E Community
WEBENCH® Design Center
Signal Chain/Signal Path Tools Forum
FilterPro Design Report
allmost all filters need more than one stage. I tried to design a filter usijg 2 stages and want to get out a nice design report. The schematic only shows the left part of the design, approximately 1.2 stages, the rest is off the paper.
Is there any workaround to fix that and maybe this is an issue to tackle with the next release.
With best regards
Are you using the latest version? I know in the very first FilterPro 3 release, we had some problem like this, but we quickly fixed that. You should be getting a report that breaks nicely so you can see everything.
If you generate a PDF of the report, does it look OK, or is this only when printing?
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.