I have not yet received my product, but I have to design related mechanical parts before I receive it.

Evan Wu85

Prodigy 80 points

< All about LightCrafter 9000 EVM >

Dear All,

Thank you for your patience to read this question, it's a little hard to find what I need on TI's website.

And I have not yet received my product, but I have to design related mechanical parts before I receive it,

so I would like to find the mechanical dimension information about:

1. Control board of LightCrafter 9000 EVM, especially the position of screw mounting holes.

2. DMD Chip board of LightCrafter 9000 EVM, especially the position of screw mounting holes, the two holes for DMD positioning and other mechanical dimension information.

actually, I can't even see a screw mounting hole in the photo on this site http://www.ti.com/tool/DLPLCR9000EVM#technicaldocuments

Any mechanical dimension information would be very helpful, thanks everybody on the forum.

Sincerely,

Evan

over 5 years ago

0 Fizix over 5 years ago

TI__Mastermind 43125 points

Hello Evan,

On the page you have linked (http://www.ti.com/tool/DLPLCR9000EVM#technicaldocuments), go to the following section (about half way down the page):

Select the link on the right of the fourth entry, "DLP LightCrafter 9000 Reference Design" and download the file. It has schematics, BOM, assembly and Gerber files for the design, including the controller and DMD boards, which will have the information you are looking for.

Fizix

0 Evan Wu85 over 5 years ago in reply to Fizix

Prodigy 80 points

Dear Fizix,

Thank you for your kindly help!

Sincerely,

Evan Wu

DLP®︎ products

DLP products forum

I have not yet received my product, but I have to design related mechanical parts before I receive it.