Hi,
I need to set the frame rate of DLP LightCommander in my project , but I can't find any way to make it. Any help is appreciated! Thank you!
Best Wishes!
Xu
Hi Xu,
Welcome to DLP&MEMS forum.
To set frame rate you need to run the "batchfile" that has complete DLPC200 configuration information. Please refer to this E2E forum thread http://e2e.ti.com/support/dlp__mems_micro-electro-mechanical_systems/f/387/p/187661/674640.aspx#674640
Let me know if you are still not clear on this.
Regards,
Sanjeev
Thank you very much for your reply!
I read the E2E forum thread http://e2e.ti.com/support/dlp__mems_micro-electro-mechanical_systems/f/387/p/187661/674640.aspx#674640. I follow as it says.
I have found the batchfile in my DLP LightCommander Project.
Can i modify the batchfile by binary editor to set the frame rate, then load the changed batchfile?