TI E2E Community
DLP & MEMS
DLP LightCrafter Development Platform Forum
About the micro-mirror's on/off positions at the "Fine Checked Board" mode in DLP LightCrafter
Dear Sir or Madam,
When LightCrafter is set at "Fine Checked Board" under "Internal Test Pattern" mode, the output is 8*14 black and white rectangles (or maybe squares).
At this condition, could I think that the micro-mirrors at the black rectangles are set to OFF positions, and micro-mirrors at white rectangles are set to ON positions?
Moerover, if it is right, how to create these kind output pattern, such as 57*76 black and white rectangles?
Thanks a lot.
Yes, you can think that the micromirrors are in 'OFF' state for black rectangles and in 'ON' state for white.
The simplest way is to create the required pattern in paint by setting the correct resolution (608*684, WVGA, VGA and QVGA are supported) and loading the pattern through GUI in pattern sequence mode (1-8 Bit) or Static image mode (24 bit).
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.