What connector do I need for J8?

Christine Swisher44

Intellectual 280 points

What connector do I need for J8? I have the lightcrafter.

Thanks for your help,

Christine

over 9 years ago

0 Clinton Rodgers over 9 years ago

TI__Genius 11255 points

Hi Christine,

Take a look at the bill of materials (BOM) in the LightCrafter reference design (http://www.ti.com/LCRdesigndoc). Is this J8 on the system board or driver board? You will need to make sure you are on the right sheet of the BOM to find the correct J8 you are referencing.

Thanks,
Clinton

0 Christine Swisher44 over 9 years ago in reply to Clinton Rodgers

Intellectual 280 points

Hi Clinton,

Thanks so much for your help. It is for the fan. Driver board I think. So I need the following. If so what vendor?

CNNT PIN M 2PIN 1.25MM RT/SMD TU1252WNR-02S "TYU" GREEN

Thanks for your help!

Christine

0 Clinton Rodgers over 9 years ago in reply to Christine Swisher44

TI__Genius 11255 points

Hi Christine,

I'm looking into an answer for you.

Thanks,
Clinton

0 Clinton Rodgers over 9 years ago in reply to Christine Swisher44

TI__Genius 11255 points

Hi Christine,

I would recommend reaching out to a distributor, such as Digikey (http://www.digikey.com/) or Mouser (http://www.mouser.com/), to find the part or an alternative.

Thanks,

Clinton

DLP®︎ products

DLP products forum

What connector do I need for J8?