Separating the projector module from processor

Any of your thoughts would be most helpful-I'll gladly share my results.

For the application I am designing, I have both the Optoma Pico and the dev. kit from digikey.

If anyone has suguestions please share.

I think the Detailed drawings will be release in a 1-2 working days.  The connector P/N will be listed.

Additionally, the bus data rate is high (200Mhz), so this would require very detailed analysis/simulation or trial and error to determine the length without incurring timing issues that would cause problems.

I can't seem to get my hands on the drawings-the folks at digikey dont have them (yet).

any thoughts?

A number of new documents (schematics, functional info) were uploaded here:

http://focus.ti.com/dlpdmd/docs/dlpdiscovery.tsp?sectionId=60&tabId=2235

Is this what you need?

I combed these docs, and still can't find what I need. Digikey doesn't have the full drawigns either. Maybe if someone has the gerber files with parts list?

Its the board to board right angle connectors that i need a name for.

Check out the Mechanical for the Pico DMD:

http://focus.ti.com/pdfs/dlpdmd/2509058-17HVGA-S210-DMDmechicd.pdf

It looks like the DMD has a Panasonic AXK6L46347G, and the sockect is Panasonic AXK5L46347G

Whether or not you can find these parts maybe the bigger issue.

Eric