Dear,
Could someone give me your advise for following?
Related posts:http://e2e.ti.com/support/dsp/tms320c5000_power-efficient_dsps/f/109/t/188803.aspx
Device: TMS320VC5507ZHH
I'd like to know how I can get the measured value of Total Conversion Time on board.Because, I can not get measured value that should be equal with calculated value of AD Conversion time.
My question: I think ADCBUSY bit in ADCDATA Register becomes high while Sample and Hold process and Conversion process. In other words, ADCBUSY=1 during 46.6uS, Total conversion time, in case of following Figure. Am I right?
Regards,Okayama
On page 9 of SPRU586B:After the conversion process completes, the ADCBUSY bit value changes from 1 to 0, indicating that the conversion data is available.
So, yes, ADCBUSY = 1 for 46.5us. Switch to 0 on next clock cycle.
Regards.
-------------------------------------------------------------------------------------------------------
Please click the Verify Answer button on this post if it answers your question
--------------------------------------------------------------------------------------------------------