UDP based communication for c6748

Axay Rana

Intellectual 580 points

Hello there,

At this point i have implemented physical communication with EMAC, PHY and MDIO. (able to loopback data from PHY)

What should i do next to achieve udp protocol based communication?

Where should i start at?

over 8 years ago

0 Axay Rana over 8 years ago

Intellectual 580 points

In addition to that i have custom board so i can not run examples from ndk or nsp however i can inspire myself from the sample codes if we have.
So don't hesitate to suggest me on that also!

0 Pavel Botev over 8 years ago in reply to Axay Rana

TI__Guru**** 170625 points

Hi Axay,

Are you using DM816x TI EVM? Are you using EZSDK 5.05.02.00?

Regards,
Pavel

0 Axay Rana over 8 years ago in reply to Pavel Botev

Intellectual 580 points

None of them actually.
Currently, i am looking at starterware examples for the enet_echo and enet_lwip projects.

0 Pavel Botev over 8 years ago in reply to Axay Rana

TI__Guru**** 170625 points

Are you using DM816x based board?

Regards,
Pavel

0 Axay Rana over 8 years ago in reply to Pavel Botev

Intellectual 580 points

Nope! i am using base design for the development kit LCDKC6748.

0 Pavel Botev over 8 years ago in reply to Axay Rana

TI__Guru**** 170625 points

Axay,

This is DM816x/AM389x/C6A816x forum, which supports DM816x/AM389x/C6A816x devices. Does your question have something common to these TI devices?

Regards,
Pavel

0 Axay Rana over 8 years ago in reply to Pavel Botev

Intellectual 580 points

I understand this.
I would try to migrate it to C6000 series DSPs.
Thanks!

Processors

Processors forum

UDP based communication for c6748