TI E2E Community
Digital Signal Processors (DSP)
OMAP-L13x, AM1x and C674x Processors Forum
RTC_Vss pin connection
I’m posting the following requirement related to the RTC_Vss pin connection.
In datasheet I can see the RTC power module is isolated.
And in the Hardware Checklist :
I can see that RTC_Vss connection to Vss is only mentioned when pin is not used.
Can RTC_Vss be connected to the general VSS or does it have to be connected to a dedicated Vss reference?
If RTC is used in your design, the recommendation is to follow the datasheet and not tie RTC_VSS to board ground.
Don't forget to verify answers to your forum questions by using the green "Verify Answer" button.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.