quickStartOMAPL1x_rCSL - registers for OBSCLK missing

Maria da Gloria Hamester

Prodigy 190 points

Other Parts Discussed in Thread: OMAP-L137

The OBSEN field of CKEN and OBSEN registers are missing on quickStartOMAPL1x_rCSL for OMAPL137.

These fields are declared as reserved on the register structure.

Is there any problem on acessing this register´s fields?

Thaks,

Gloria

over 7 years ago

0 Mukul Bhatnagar over 7 years ago

TI__Guru* 78475 points

Hi Gloria
That is a very old software package and not refreshed (it is posted as is)
The OBSEN fields were documented later and are supported - no issues accessing these register fields as documented in the TRM
Regards
Mukul

0 Maria da Gloria Hamester over 7 years ago in reply to Mukul Bhatnagar

Prodigy 190 points

Mukul,
Thank you!
By the way, do you know if there is a silicon errata for silicon revision 4?
SPRZ291I is just for 3.0, 2.1, 2.0, 1.1, and 1.0 silicon revision.
Regards,
Gloria

0 Senthilkumar Srinivasan over 7 years ago in reply to Maria da Gloria Hamester

TI__Mastermind 43660 points

Hello Gloria,

What is the full part number of the device you are using ?

There is no silicon revision 4.0 device available for OMAP-L137. It gone through up to revision 3.0 only.

Regards,
Senthil

0 Maria da Gloria Hamester over 7 years ago in reply to Senthilkumar Srinivasan

Prodigy 190 points

Hello Senthil,

The full part number is OMAPL137DZKBD4, that means 4 device speed, but silicon revision 3.0.
Is there any documentation of diferences from speed 3 and speed 4?
Regards,
Gloria

0 Senthilkumar Srinivasan over 7 years ago in reply to Maria da Gloria Hamester

TI__Mastermind 43660 points

Hello Gloria,

The device speed range 3 is 375 MHz and the speed range 4 is 456 MHz. The device datasheet covers this difference (refer Figure 6-1. Device nomenclature).

Regards,
Senthil

0 Maria da Gloria Hamester over 7 years ago in reply to Senthilkumar Srinivasan

Prodigy 190 points

Thank you Senthil.

Processors

Processors forum

quickStartOMAPL1x_rCSL - registers for OBSCLK missing