problem in write permanent the code on the flash

mostafa saad

i have a problem i try to burn the code using Spiwriter but the code doesn't work well,but when i debug using blackhawk the code works well

over 7 years ago

0 Shankari G over 7 years ago

TI__Mastermind 43955 points

Hi mostafa saad,
Please make sure that you have configured the AIS settings properly like PINMUX, PLL settings.
Try to flash simple LED or UART code to your flash device.

0 mostafa saad over 7 years ago in reply to Shankari G

Prodigy 30 points

i'm very sure about it

0 Shankari G over 7 years ago in reply to mostafa saad

TI__Mastermind 43955 points

Hi mostafa saad,
What example are you flashing ?
Your own code or any TI example ?
To understand the boot procedure, please try to flash the simple LED project to your board.
processors.wiki.ti.com/.../Boot_Images_for_OMAP-L138

0 mostafa saad over 7 years ago in reply to Shankari G

Prodigy 30 points

i try my own code

0 Shankari G over 7 years ago in reply to mostafa saad

TI__Mastermind 43955 points

Hi mostafa,

Try something which already works and that would be a good starting point.

processors.wiki.ti.com/.../Boot_Images_for_OMAP-L138

Processors

Processors forum

problem in write permanent the code on the flash