Other Parts Discussed in Thread: OMAPL138
Hi,
We built a customize board based on OMAP L138 REV-E.
Silicon Id - 2.3
Earlier, we were using processor with Silicon ID - 2.1 and below. UART boot is working with sfh_OMAP-L138.exe.
We didn't done any changes with the board only processor got changed to Silicon ID 2.3.
UART boot is no longer working. I'm getting below error, while below command
sfh_OMAP-L138.exe -erase -p COM1
-----------------------------------------------------
TI Serial Flasher Host Program for OMAP-L138
(C) 2012, Texas Instruments, Inc.
Ver. 1.67
-----------------------------------------------------
[TYPE] Global erase
[TARGET] OMAPL138
[DEVICE] SPI_MEM
[SPI Block] 0
Attempting to connect to device COM1...
Press any key to end this program at any time.
(AIS Parse): Read magic word 0x41504954.
(AIS Parse): Waiting for BOOTME... (power on or reset target now)
(AIS Parse): BOOTME received!
(AIS Parse): Performing Start-Word Sync...
(AIS Parse): Performing Ping Opcode Sync...
(AIS Parse): Processing command 0: 0x58535901.
(AIS Parse): Performing Opcode Sync...
(Serial Port): Read error! (The operation has timed out.)
(AIS Parse): I/O Error in read!
(Serial Port): Read error! (The operation has timed out.)
(AIS Parse): I/O Error in read!
(Serial Port): Read error! (The operation has timed out.)
(AIS Parse): I/O Error in read!
(Serial Port): Read error! (The operation has timed out.)
(AIS Parse): I/O Error in read!
(Serial Port): Read error! (The operation has timed out.)
(AIS Parse): I/O Error in read!
(Serial Port): Read error! (The operation has timed out.)
(AIS Parse): I/O Error in read!
(Serial Port): Read error! (The operation has timed out.)
(AIS Parse): I/O Error in read!
(Serial Port): Read error! (The operation has timed out.)
(AIS Parse): I/O Error in read!
(Serial Port): Read error! (The operation has timed out.)
(AIS Parse): I/O Error in read!
(Serial Port): Read error! (The operation has timed out.)
(AIS Parse): I/O Error in read!
(Serial Port): Read error! (The operation has timed out.)
(AIS Parse): I/O Error in read!
(AIS Parse): Opcode Sync failed after 11 consecutive I/O failures.
(AIS Parse): Boot aborted.
Booting SFT failed. Trying again (you may need to reset the target)...
(AIS Parse): Read magic word 0x41504954.
(AIS Parse): Waiting for BOOTME... (power on or reset target now)
Aborting program...
(Serial Port): Read error! (Thread was being aborted.)