TI E2E Community
Digital Signal Processors (DSP)
C6000 Single Core DSP
C67x Single Core DSP Forum
I am experimenting with alarm wake up from deep sleep in a C6748. I would like to set an alarm some arbitrary delta from the current RTC value. To do so, I need to convert date/time to seconds since 00, add the delta, and convert back to data/time. The TRM mentions leap year support. I assume that means 21 century. No warping back to the 20th.
What is algorithm does the RTC module use to increment all it's internal counters?
Otherwise, I have to use the RTC module like a timer and zero it out for every timing duration.
Thanks for your post.
First of all, it is not possible to configure the output behavior of the RTC_ALARM pin as a one second periodic pulse, however the ALARM interrupt can be used to generate a pin toggle through GPIO and the the RTC_ALARM signal behaviour is described by a diagram in the C6748 TRM (Section 9.9.3, page no. 200, under "Deep Sleep Mode" -> "Deep Sleep Sequence") as below:
You can configure the Deep Sleep mode in both modes (externally controlled wake-up & RTC controlled wake-up). Also, please refer Section 9.7 (RTC-Only Mode) and Section 9.9 (Deep Sleep Mode) for better idea on how DEEPSLEEP pin is driven from low to high and how it begins counting valid clock cycles.
Please refer the below E2E threads in which you can get an better understanding on the above two modes (RTC-Only mode and Deep Sleep Mode):
I hope the above information would be useful to you.
Thanks & regards,
I did try periodic interrupts. I set up a 1 second periodic interrupt and a 10 second alarm in the future. I then put the processor in deep sleep. It did not wake up at 1 second. It did wake up at 10 seconds. The block diagram in TRM Section 26.1.3, Figure 26-1 would suggest that Alarm interrupts are separate from Timer interrupts. No where else in the TRM does it document where those interrupts are connected. It is implied that RTC_ALARM pin is the same line as the Alarm interrupts in the figure.
My custom board does not have GP0/DEEPSLEEP/RTC_ALARM pin connected to an external point. Next revision. Externally controlled wake-up is not at option at this moment.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.