EtherCAT Application on TMDXICE3359; Interrupt Routine for Output LEDs

Hendrik Klasen

Intellectual 770 points

Hey there,

i'm going through the code of the full EtherCAT-Application for the TMDXICE again and again.

Nevertheless i can't find the function where the Output LEDs (the array of eight LED) were set.

Where should i take a look at?

Kind regards,

Hendrik

over 9 years ago

0 Vinesh Balan over 9 years ago

TI__Expert 7360 points

Hendrik,

The Output LEDs are controlled by I2C. Please see the task - LEDtask in tiescutils.c(set by LEDDIGOUTSetVal)

Regards,
Vinesh

0 Hendrik Klasen over 9 years ago in reply to Vinesh Balan

Intellectual 770 points

Vinesh,

as i understand the code correctly this is the initialization LED setup.
i'm looking for the LED set when using TwinCAT.
There i can control every single LED by turning on/off.
Where can i find this Interrupt routine?

Kind regards,

Hendrik

0 Vinesh Balan over 9 years ago in reply to Hendrik Klasen

TI__Expert 7360 points

Sorry about that. You can find the code in tiescappl.c(Demo_Application if you are using the demo application)

Regards,
Vinesh

Processors

Processors forum

EtherCAT Application on TMDXICE3359; Interrupt Routine for Output LEDs