Can not display UIA Log in CCS

WEI YAN3

Prodigy 30 points

Hi,

I tried get the UIA log via UDP packet on 6614 EVM board.

The wireshark indicates the UIA packets are arrived at destination PC but the CCS have no output.

I attached a small piece of wireshark log and my CCS config.

Thanks for your time

Best Regards

Wei

UIA Fail.zip

over 9 years ago

0 ToddMullanix over 9 years ago

TI__Guru* 96960 points

Which version of UIA and CCS are you using.

I've looped in someone from the CCS team also.

Todd

0 Bruce Lee (SDO) over 9 years ago

TI__Prodigy 690 points

Hi Wei,

Would you mind to send me the following files for further analysis:

- c:/users/ywei/workspace_v5_1/dvt/systemAnalyzerData.bin

- 3 generated files from each of your project (???.out, ???.rta.xml & ???.uia.xml)

Regards,

Bruce

0 WEI YAN3 over 9 years ago in reply to ToddMullanix

Prodigy 30 points

Hi, Todd

I am using uia_1_01_03_25 and CCS Version: 5.1.1.00031

Regards

Wei

0 WEI YAN3 over 9 years ago in reply to Bruce Lee (SDO)

Prodigy 30 points

Hi, Bruce

The size of c:/users/ywei/workspace_v5_1/dvt/systemAnalyzerData.bin is 0. I am not sure if it is because of running several other debugging session after I tried UIA.

The 3 generated files are attached

4743.UIA.7z

Actually, I've post this question in TI DSP support proxy for a while and be asked to post the question here. So those generated files are latest one, not the one I tried before. But I suppose them have the same issue.

Anyway, looking forward your reply. Thanks

Regards

Wei

0 Bruce Lee (SDO) over 9 years ago in reply to WEI YAN3

TI__Prodigy 690 points

Hi Wei,

Would you please run the System Analyzer again.

If you can see UDP packets from WireShark, the same packets will stream to the bin file as well.

Note that the bin file will be cleared before every SA launch even a cancelled one. So please copy the files out to another location right away after running SA.

Bruce

Processors

Processors forum

Can not display UIA Log in CCS