I want to use KITL for my application debug.
but my USBFN RNDIS KITL communication is too slow (about 20~30KB/s with download image 30~60MB) and
my system shutdowns soon after image download finished.
my board is, Technexion Tao3530 Thunder board using OMAP3530.
Can you guess any reason for it?
and additionally, is there any way to boot from SD card with KITL enabled?
Kim, Woo Young.
Have you tried to contact Technexion for support on their board & BSP? This site is really only intended for support of TI-provided products.
Regards, Gary Tominovich
Please click the Verify Answer button on this reply if it answers your question
Sorry, I'm trying to contact them first ^^;
But I'm a regular customer of TI, and your e2e community impressed me very much,
Would you please let me know if there is any way to boot from sd card with kitl enabled?
Thanks and have nice days~
Kim, Woo Young
I am not sure if i understand your question - but if you use TI WINCE ARM A8 BSP for Mistral EVM3530, then (a) you can download the NK.bin over ethernet when booting from SD card. (b) if your NK.bin has KITL enabled, then it can connect when kernel boots up, regardless of where the eboot, xldr and Nk.bin are located.
But since this a very specific BSP feature, you will have to contact your BSP vendor to know for sure.
Please click Verify Answer button if this response answers your question. For updated information on TI WINCE BSP, please check out the WinCE Handbook.
Thank you for your replies, I succeeded to boot from sd card with KITL enable. and my device looks stable enough ^____^
I post my settings as a reference
Have nice days~
Main: Boot device: NK from SDCard FILE Debug device: USBFn RNDIS Retail Msgs: disabled Device ID: 0
SDCard: Filename: "nk.bin"
Network: KITL state: enabled KITL type: active KITL mode: interrupt DHCP: disabled IP address: nnn.nn.nn.nn IP mask: 255.255.255.0 IP router: nnn.nn.nn.n Eth MAC Addr: Invalid Ethernet chip ID (0xe000e0)!Controller not found! VMINI: enabled Note: USBFN RNDIS MAC Addr cannot be changed.
<platform builder - connectivity option configuration>
Download Image : Never (jump to image only) - checked
KITL settings : enabel KITL on device boot, Clear memory on soft reset, Enable access to desktop files - all checked
I upgreaded my 5 year old PC and installed all the programs again... And KITL communication bandwith became above 600KB/s !!! ㅠ.ㅠ
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.