Is this device received AC coupling?
I would like to connect AC coupling to input and output.
you need to externally ac couple the signals.
Thank you for the replay.
I need to V-by-One signals.
we plan to mux externally AC coupled signals up to 5GHz over HD3SS3412.
When VIO_DIFF = 1.0V and VIO_CM = 0.0V, we are a bit concerned about the negative swing of -0.5V being at the absolute maximum rating of differential IO.
Is it recommended to adjust VIO_CM with a resistor network or can we do without due to parasitic impedances?
Advice very welcome, thanks.
There should be no issue, the recommendation is to populate a place holder for the biasing resistor.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.